Configurasi OSPF Point-To-Point || Bestpath Network

point-to-point

Pengertian

Point to point adalah koneksi hanya pada dua titik tertentu. Pada point to point paket yang dikirim oleh router hanya akan memiliki satu penerima dikarenakan point to point hanya bisa melakukan routing pada 2 perangkat, dan apabila 2 perangkat tersebut telah di routing point to point router lain tidak akan bisa nyambung, point to point tidak mempertahankan hubungan DR/BDR.

Konfigurasi Point To Point

Router 1

--- System Configuration Dialog ---

Would you like to enter the initial configuration dialog? [yes/no]: n

Press RETURN to get started!

Router>enable

Router#configuration terminal

Enter configuration commands, one per line.  End with CNTL/Z.

Router(config)#int g0/0/0

Router(config-if)#ip add 10.10.10.1 255.255.255.252

Router(config-if)#ip ospf network point-to-point (Tingal tambahkan perintah ini)

Router(config-if)#no sh

Router(config-if)#

%LINK-5-CHANGED: Interface GigabitEthernet0/0/0, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0/0, changed state to up

Router(config-if)#ex

Router(config)#router ospf 10

Router(config-router)#network 10.10.10.0 0.0.0.3 area 0

Router(config-router)#exit

Router(config)#do wr

Building configuration...

[OK]

Router(config)#

00:05:00: %OSPF-5-ADJCHG: Process 10, Nbr 10.10.10.2 on GigabitEthernet0/0/0 from LOADING to FULL, Loading Done

Router 2

--- System Configuration Dialog ---

Would you like to enter the initial configuration dialog? [yes/no]: n

Press RETURN to get started!

Router>enable

Router#configuration terminal

Enter configuration commands, one per line.  End with CNTL/Z.

Router(config)#int g0/0/1

Router(config-if)#ip add 10.10.10.2 255.255.255.252

Router(config-if)#ip ospf network point-to-point

Router(config-if)#no sh

Router(config-if)#

%LINK-5-CHANGED: Interface GigabitEthernet0/0/1, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0/1, changed state to up

Router(config-if)#exit

Router(config)#router ospf 10

Router(config-router)#network 10.10.10.0 0.0.0.3 area 0

Router(config-router)#

00:04:53: %OSPF-5-ADJCHG: Process 10, Nbr 10.10.10.1 on GigabitEthernet0/0/1 from LOADING to FULL, Loading Don

jika sudah bisa adi cek hasinlnya apakah berhasil atau tidak

oke berhasil ternyata silahkan bisa di coba 

Referensi

> Sharing bersama mas Ferdi Ardiansyah

Selamat menikamati ilmu